Beam Sizing & Load-Bearing Wall Removal Drawing Free Download
Free sample beam sizing and load-bearing wall removal drawing PDF for a load-bearing wall removal or a widened opening. See the sheets, notes and details plan reviewers expect before you apply for your permit.
Planning a load-bearing wall removal or a widened opening and not sure what your building department expects to see? Download our free sample beam sizing and load-bearing wall removal drawing below. It is a real set we prepared for a past project, with client details removed, so you can see how the sheets are organized and what plan reviewers usually ask for.
What's in the free sample
The PDF has two sheets taken from a real permit set we drew for a past client:
- Existing and proposed floor plans showing the wall to be removed
- New beam, post and footing details
Client names, addresses and parcel details have been removed, and every sheet is marked "Free sample – not for construction". The structural calculations, general notes and the remaining sheets are not included. This file is for reference only: it shows the level of detail a plan reviewer expects, but it cannot be submitted for a permit.
Get the free sample PDF by email
What your building department will check
- What the wall supports: roof, floor, attic storage
- Beam span and material (LVL, steel or dimensional lumber)
- Point loads at each end and the footing under them
- Flush or dropped beam
- Temporary support during construction
How to use this sample
- Compare it with your city or county permit checklist.
- Use it to sketch your own project and gather the information you need.
- Share it with your contractor so everyone agrees on the scope.
Important: this sample is for reference only. It is not stamped, and it was drawn for a different address, code and loads. Do not submit it for your permit.
Tips before you start
- Photograph the wall, the ceiling and the floor above it.
- Measure the room and note joist direction from the attic or basement.
- Never remove a wall before the beam is sized and approved.
When you need custom drawings
Most cities need drawings made for your exact address, size and local code, and some also require a professional engineer's stamp. We prepare permit drawings for projects in all 50 states and send a fixed quote within 24 hours. If your city requires a stamp, it comes from an independent licensed PE under a separate arrangement.
See our beam sizing & calcs drawings
Frequently asked questions
Can I use this free beam sizing and load-bearing wall removal drawing for my permit?
No. It is a reference sample. Your permit set must match your address, size and local code.
Is the drawing stamped by an engineer?
No. A stamp is only added to custom drawings when your city requires one, by an independent licensed PE under a separate arrangement.
What file format is the download?
A PDF you can open on any computer or phone and print.
Get a quote for your project
Tell us about the project. We'll ask any questions we need, then send a fixed price and timeline. No payment until you approve the quote.
- Send sketches, photos or old plans
- [email protected]
- Response time
- Usually within 24 hours
- Coverage
- Projects in all 50 states
- We review your projectand ask any questions, usually the same day.
- You get a fixed quotewith price and timeline. No payment until you approve.
- We draft and reviseuntil the set is ready to submit for your permit.
Plans were delivered fast and communication was excellent. Willing to do revisions as needed to make sure everything meets requirements.
Thanks, we got your project.
We'll email your fixed price and timeline, usually within 24 hours.